11/06/2016

Which is the best port trunking option ON QNAP

Which is the best port trunking option ON QNAP

Below are the 6 options available:

Balance-rr (Round-Robin)
Round-Robin mode is good for general purpose load balancing between two Ethernet interfaces. This mode transmits packets in sequential order from the first available slave through the last. Balance-rr provides load balancing and fault tolerance.
Supports static trunking. Make sure static trunking is enabled on the switch.


Balance XOR
Balance XOR balances traffic by splitting up outgoing packets between the Ethernet interfaces, using the same one for each specific destination when possible. It transmits based on the selected transmit hash policy. The default policy is a simple slave count operating on Layer 2 where the source MAC address is coupled with destination MAC address. Alternate transmit policies may be selected via the xmit_hash_policy option. Balance XOR mode provides load balancing and fault tolerance.
Supports static trunking. Make sure static trunking is enabled on the switch.

Broadcast
Broadcast sends traffic on both network interfaces. This mode provides fault tolerance.
Supports static trunking. Make sure static trunking is enabled on the switch.

IEEE 802.3ad (Dynamic Link Aggregation)
Dynamic Link Aggregation uses a complex algorithm to aggregate adapters by speed and duplex settings. It utilizes all slaves in the active aggregator according to the 802.3ad specification. Dynamic Link Aggregation mode provides load balancing and fault tolerance but requires a switch that supports IEEE 802.3ad with LACP mode properly configured.
Supports 802.3ad LACP

Balance-tlb (Adaptive Transmit Load Balancing)
Balance-tlb uses channel bonding that does not require any special switch. The outgoing traffic is distributed according to the current load on each Ethernet interface (computed relative to the speed). Incoming traffic is received by the current Ethernet interface. If the receiving Ethernet interface fails, the other slave takes over the MAC address of the failed receiving slave. Balance-tlb mode provides load balancing and fault tolerance.
General switches

Balance-alb (Adaptive Load Balancing)
Balance-alb is similar to balance-tlb but also attempts to redistribute incoming (receive load balancing) for IPV4 traffic. This setup does not require any special switch support or configuration. The receive load balancing is achieved by ARP negotiation sent by the local system on their way out and overwrites the source hardware address with the unique hardware address of one of the Ethernet interfaces in the bond such that different peers use different hardware address for the server. This mode provides load balancing and fault tolerance.
General switches

No comments:

Post a Comment